Hello Guest it is March 29, 2024, 05:18:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MicroSD

Pages: 1
1
General Mach Discussion / Slow multiaxis feed
« on: December 04, 2016, 02:18:51 PM »
Hi

The problem is that machine won't reach to g-code feeds. Every time when tool-path changes direction machine slows down. Is there any way to cancel such behavior or is this controller based issue?
Controller is some sort E-Cut controller, pic:  http://imgur.com/a/8P88H
Video of described behavior: https://youtu.be/0NyqkZ0JZpk

Haas has g187 smoothness parameter is there any chance that Mach 3 could have same kind setting?


Best Reagards!
MicroSD

Pages: 1