Hello Guest it is November 20, 2019, 09:05:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Inchy

Pages: 1
1
Show"N"Tell ( Your Machines) / EMCO newbie
« on: November 30, 2016, 08:14:48 PM »
My school has an old EMCO Compact 5 PC that I would like to get going again. I've been reading and sending emails all over the place and I think I've come up with a parts list but I would really like people's opinions.

Motor Controller : Pokeys 57CNC
Motor Drive: Gecko G540
A couple of toroidal power supplies for the new boards.
Mach 4 software

I've never attempted anything like this so any advice would be greatly appreciated.

Pages: 1