Messages

1

General Mach Discussion / Re: Another Feed rate velocity issue

« on: November 24, 2016, 07:30:00 AM »

Hi mike,
Thanks for the response.
All metric here
Sets per mm 480.347716
USB board is a WXHC MKX-IV
No idea what it's max stepping rate is?

I have got the speeds resembling closer to what they should, factory had the kernel speed set at 100khz
Reducing it to 25000hz makes it somewhat resemble my other machines.
I still have the minor issue of it not taking a minute to travel 25mm when the feed rate is 25
It takes around 50secs no matter what I do.

Cheers

2

One on one phone support. / Re: About one on one phone support.

« on: November 24, 2016, 01:31:21 AM »

Hi,
I would like Australian Phone Support.
darren at allaxis.com.au
O4O3 121 338

3

General Mach Discussion / Another Feed rate velocity issue

« on: November 23, 2016, 09:35:58 PM »

Hi All,
After spending days looking through the forum I have finally joined to ask for help.
Normally you can find the answers with a decent hunt but this eludes me probably through terminology.
I have purchased a router from china, everything is running as intended at this stage other than feed rates.
I did use the USB that came with the machine and copied those files over my original install

In motor tuning velocity is set to 10002 for X & Y
Maximum speed i get is 2500 on GO
when i run code G1 Y1000 F2500 gets a feed rate of approx 1000
G1 X1000 F2500 gets around 600
This is replicated if entered in the MDI
If I go G1 Y25 F25 it takes about 60 seconds

If anyone could highlight where to look for the issue or some troubleshooting techniques it would be appreciated.
Hopefully I can start contributing as much as the rest of the folks around here now 
Many Thanks