Messages

1

General Mach Discussion / Re: Computer shuts down

« on: November 12, 2016, 01:24:17 AM »

 Btw... I tried 3 different xp computers in my house, downloading mach3 and got the shut down situation problem with all three.
Tried optimization from the site here as well, no change.  NO BLUE screens though  on this shut down stuff.  Still no answers.


bob

2

General Mach Discussion / Re: Computer shuts down

« on: November 12, 2016, 01:15:31 AM »

I am having exactly the same problem with windows xp computer... runs fine until Mach 3 runs... then screen blinks a couple times and it shuts down and turns off.  Its worse with the cnc power supply turned on.  Paid a tec guy to do the xp setup to follow the optimization sheet from the site here... no improvement.  This issue of course completely stops any movement forward.  will post this on individual post, but if someone reads this please reply

thanks bob

3

General Mach Discussion / Re: Computer shuts down on Mach 2 & 3 boot up.

« on: November 12, 2016, 01:10:46 AM »

John could you tell me what article you read on device drivers?  I seem to have something of your problem.

thanks bob

4

General Mach Discussion / Re: mach3 or computer problem

« on: November 12, 2016, 01:08:14 AM »

Martin... I am having the same problem of computer shutting down... did you ever find a solution on this problem

bob