1
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 04, 2016, 12:07:11 PM »
I've found the issue, the enable input from stepper motor driver, disable the driver with 5 volts an enable with 0 volts.
So, it's possible to run mach3 with the next components:
PC Desktop HP Pavilion Slimline s3020la - Windows 7 32 bits
Manhattan - Parallel PCI Card (158220)
Longs Motor - Breackout Board (D25/Paralel port)
Longs Motor - Stepper Motor Driver DM420A
Longs motor - Stepper Motor Nema 17 - 48 oz. in. - 4 Leads - 1.7 Amps.
Thanks Tweakie for your support.
Mario Gutierrez
So, it's possible to run mach3 with the next components:
PC Desktop HP Pavilion Slimline s3020la - Windows 7 32 bits
Manhattan - Parallel PCI Card (158220)
Longs Motor - Breackout Board (D25/Paralel port)
Longs Motor - Stepper Motor Driver DM420A
Longs motor - Stepper Motor Nema 17 - 48 oz. in. - 4 Leads - 1.7 Amps.
Thanks Tweakie for your support.
Mario Gutierrez