Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tothemaking

Pages: 1
1
Share Your GCode / Re: Bentley logo G codes help
« on: November 15, 2016, 08:23:45 AM »
See if you can open your .dxf in AutoCad then save it as a different version .dxf

Tweakie.

i did new one on CamBam but the parts are not joined together , i tried to do join with tolerance 0.001 but still it wont join at one piece
Can you help me with that

2
Share Your GCode / Re: Bentley logo G codes help
« on: November 15, 2016, 04:23:39 AM »
i did it while using the Autocad drawing that i made

is there away to fix it ?

3
Share Your GCode / Re: Bentley logo G codes help
« on: November 15, 2016, 04:11:44 AM »
here

4
Share Your GCode / Re: Bentley logo G codes help
« on: November 15, 2016, 03:20:42 AM »
this is the pdf
and the dxf said its too big to attach :/ and when i try to open it on cambam it wont work .

5
Share Your GCode / Re: Bentley logo G codes help
« on: November 15, 2016, 03:17:47 AM »
Thank you!
I am not sure if this helps you or not …

For a 2D part, starting out with a logo in .jpg form I have converted it to a .dxf then created the Gcode for an engraving toolpath of the outline of the image and attached the relevant files.

Creation of a 3D (2.5D) part requires quite a lot more work - you either find (on the net) or create a depth map image of your logo then generate a 3D toolpath from that image.

Tweakie.

The G codes in my book look little different they are like ( G90 , G01, G12 etc)

I tried to change the autocad drawing into dxf and then use cambam to get gcodes but it didn't work for me :/  , i dont know why
I attached them just in case someone will be able to help me with it

6
Share Your GCode / Re: Bentley logo G codes help
« on: November 14, 2016, 12:37:39 PM »
If i put PDF file can someone help with the g codes?


7
Share Your GCode / Bentley logo G codes help
« on: October 29, 2016, 12:49:36 PM »
Hi friends! i just came cross this forum and saw how helpful this community is.
I would like to ask for your help . Can anyone help me with G codes for Bentley logo , i will be doing it on an aluminum sheet ( dimension  400mm x 350mm , 1mm depth )
i have attached the logo and example of the final cut out/ the result of the cut


If anyone can help me that will be so great !!  Thank oyu

Pages: 1