Messages

1

General Mach Discussion / Re: arrow Keys will not move x and y motors see more....... info

« on: November 25, 2019, 05:47:23 PM »

continueuis,  can;t find the last one one?

2

General Mach Discussion / arrow Keys will not move x and y motors see more....... info

« on: November 25, 2019, 02:52:24 PM »

arrow Keys will not move x and y axis motors from the keyboard. motors do jump when first turned on. using the jog function with the tab  does move the x and y axis but only very slowly. no speed control. I have inserted the plug in in the plug in folder. and the other one in the folder
This is a cross fire plasma table using win 7 on a dell laptop computer.  Thanks for looking and helping.
no g-code function either.

3

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 21, 2016, 08:06:52 PM »

Fellas, I have sent the BOB back to the seller to have it checked out before continuing this fix so please bare with me for a week or so  Thanks you guys....:O)   Ward

4

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 21, 2016, 04:26:29 PM »

I need a few days to investigate this matter,,  Ward.

5

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 21, 2016, 11:18:01 AM »

Hello Tweakie,  Will cherck that ASAP.   Thanks  Ward.

6

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 21, 2016, 09:35:35 AM »

Hello Tweakie,

The Step & Direction pin allocations in Motor Outputs do not match the .pdf document (manual) you have attached in post #22.
Not sure what you want me to do here I have them set as per the manual 2/3 4/5 6/7 ..Ward

7

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 20, 2016, 12:34:42 PM »

Hi Craig,Tweakie
made those changes  5 but no change. Mach3 shows dro working when left and right buttons pushed. no motor movement.
I think now is the time to take the BOB out and recheck all sodier joints and components. I will do that the rest of the day If I replace it to no avail, I will buy another one.

8

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 20, 2016, 11:37:29 AM »

Hi Tweakie,  this XML file opens in internet explorer.

9

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 19, 2016, 12:39:20 PM »

Hello Fellas,  from the motor tuning page.
steps per   = 8000
velocity       = 101.64
acceralation  =4   g s 0.0103607
step pulse  = 0      dir pulse=0   Ward.

10

General Mach Discussion / Re: No communication between computer and controller box.

« on: December 19, 2016, 12:30:55 PM »

Hello Fellas, checked the 25 pin connector cable all pin match their respective numbers.
attached is the xml file.  Ward.