Guest
Show Posts
1
General Mach Discussion / motor tuning help
« on: January 25, 2017, 02:35:51 PM »
I have a G0704 I am converting and need some help
I would like to know where to start on the steps per.
Is there a general starting point?
C11 BOB
X,Y nema 23 570oz-in
Z nema 34 906oz-in
Ball screws are RM-16 Metric C7 grade ball screws. 5mm Pitch (.508 TPI) if this helps not sure how to figure it out.
Thank you
Joseph
I would like to know where to start on the steps per.
Is there a general starting point?
C11 BOB
X,Y nema 23 570oz-in
Z nema 34 906oz-in
Ball screws are RM-16 Metric C7 grade ball screws. 5mm Pitch (.508 TPI) if this helps not sure how to figure it out.
Thank you
Joseph