Hello Guest it is March 29, 2024, 01:07:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jhsigns

Pages: 1
1
General Mach Discussion / Re: Newbie needs help
« on: October 24, 2016, 11:16:51 AM »
I found out watching the last test, that one side of the gantry is dead, the other is just dragging it around. That is the problem!
Thanks guys, sorry to waste your time!

2
General Mach Discussion / Newbie needs help
« on: October 24, 2016, 10:29:11 AM »
Hello All!
I have been routing about 9 months without any real problems I couldn't figure out. Friday it happened on a VERY simple job. I tried setting up the file all over from scratch today and got the same result. Tried some different CV settings friday with no change. Any help would be greatly appreciated. these are 5'' squares with 4 round holes in them, It won't make anything correct! I'm thinking something small and stupid, like a setting, but I can't figure it out. You can see I tried changing the way it was routing conventional/climb, just had opposite reaction. Notice how crazy the holes are! 2 are perfectly wrong on each piece and 2 are completely wrong from hole to hole piece to piece.

Pages: 1