Messages

1

G-Code, CAD, and CAM discussions / Re: Problem running demo G-code "scorpion.tap"

« on: October 12, 2016, 02:31:55 PM »

Hi would appreciate if you have manage to solve your problem. I have been looking into changing my Chinese board problem and fitting a smooth stepper USB or Ethernet? How easy or tough is this to do , any wiring diagram set up would be much appreciated.

2

Building or Buying a Wood routing table.. Beginnners guide.. / Wiring of yoocnc 450 Kjb parallel port card to newforever inverter for Mach3 co

« on: October 11, 2016, 02:18:37 AM »

Hi, hopping someone has done this. I have a yoocnc parrellel port card on 6040 machine and want to wire this in to run  newforever inverter
Using Mach3. There are 3 pins on the board, but don' t know whether these are opts isolated ? The can be configured to apply 0-10v signal to the inverter. any advise appreciated.