Hello Guest it is March 29, 2024, 06:22:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - larsken

Pages: 1
1
General Mach Discussion / Re: Hall of shame
« on: October 03, 2016, 06:58:19 AM »
Thanks Tweakie  I appreciate your help! I ran across your website when I was trying to figure this out. I am new to CNC. I have built several 3d  printer and have run manual lathes for many years
It is nice to know I can find help here!
Thanks again
Ken

2
Thanks Jim I appreciate your help!
Ken

3
General Mach Discussion / Re: Hall of shame
« on: October 02, 2016, 04:46:38 PM »
So I am guessing the reason I have boxes across the top of my screen where the drop down menus are supposed to be: file config help etc means the oem copy of mach 3 that came with my chinese 6040 engraver router mill is pirated?  Please confirm and I will purchase license immediately!!!

Thanks,
Ken

4
General Mach Discussion / Headers missing from oem 6040 Chinese engraver
« on: October 02, 2016, 04:17:25 PM »
Does anyone have just boxes going across there Mach 3 where there should be english titles
where it normally says
file  config help etc...

Do I need to buy a new copy of Mach 3?
Thanks,
Ken

Pages: 1