Hello Guest it is February 07, 2023, 06:24:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Csaba911

Pages: 1 2 3 »
1
General Mach Discussion / Vacuum on Flooding
« on: August 25, 2007, 12:03:48 PM »
Is it possible to have like a SSR Relay hooked up to some pin (like Flood) and have it periodicaly sucking up the dirt automaticaly.
I mean I don't want to reinvent the wheel. But can somebody head me the right direction. Just like the Spindle enable/disable .
And you probably have to insert the gcode manualy, right ?


2
General Mach Discussion / Cut Circle in metric
« on: August 25, 2007, 12:00:34 PM »
HI ,

I'm not sure but I believe the cut circle wizard is not metric. Can somebody verifiy that ?
I use MACH 3

3
General Mach Discussion / Re: Spindle Control
« on: July 09, 2007, 09:17:01 AM »

4
General Mach Discussion / Re: Spindle Control
« on: July 08, 2007, 08:01:14 PM »
Yes it's the proxxon MF-70 it has alittle knob wher you can vary from 2 to 20 '000 rpm . VFD I don't know what that is ?

5
General Mach Discussion / Re: Spindle Control
« on: July 08, 2007, 07:52:04 PM »
Still not working .. I have no speed control.

6
General Mach Discussion / Re: Shapes / Run from here ???
« on: July 08, 2007, 07:50:54 PM »
I was able to cut the 25pin d-sub on line 61 and then I put in a new piece to cut and it started from the first again. So I know it is possible but how ?
What wizard does shapes ??  I mean the D-Sub ??
Also I had to scale it up by 2.54. Also it states I should use no thicker than a 0.125 bit but my bit is about 3mm . Is there bit this thin even gonna hold the stress ?

7
General Mach Discussion / How to reduce overall workspeed
« on: July 08, 2007, 06:11:43 PM »
HI, I was gonna ask if it was possible to work some defined percentage slower than the machine would operate . But not line by line. Just reduced speed?

8
G30 and enter works wonders for me. I just want to go to Zero so I can take out the piece i 've been working on. Aparently Safe-Z is not gonna work since that is part of the software . I should write a macro instead.

9
General Mach Discussion / Re: Help File ?
« on: July 06, 2007, 06:30:22 PM »
OK I found it under tutorials. How stupid of me. But I couldn't find any list of all the key commands. I want do define GOTOZ to a Key shortcut. Also it would be nice to have SoftLimit on a key as well. Can that be user defined ?

10
General Mach Discussion / Help File ?
« on: July 06, 2007, 05:54:14 PM »
I s there a help file or some sort of documentation for MACH 3 cause the wizard don't know much. And I'll be waiting to answer my questions for days. I could't find anything to download.


Pages: 1 2 3 »