Hello Guest it is September 29, 2020, 03:35:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gravie

Pages: 1 2 3 4 5 6 »
1
Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT
« on: March 19, 2018, 01:06:21 AM »
one is for the gearbox an the other is for the horizontal spindle.

3
Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT
« on: February 18, 2018, 07:29:12 AM »
before

4
Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT
« on: February 18, 2018, 07:24:20 AM »
hallo slovenec,
it runs, but it needs fine tuning.

there are on all axis belt driven ball screws without gears.

5
CS-Lab / Re: Motor tunning with CSMIO/IP-A (PID) Trouble with encoders
« on: February 09, 2017, 06:46:47 AM »
https://www.machsupport.com/forum/index.php/topic,33125.msg236542.html#msg236542

the gear changing works.... not perfekt, but ist works.  i must now optimize the spindlespeed macro.


6
Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT
« on: February 05, 2017, 12:07:10 PM »
picture

7
Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT
« on: February 05, 2017, 12:05:17 PM »
the gear changing works, but still not perfect

https://youtu.be/y3hXnMe5g_8

8
CS-Lab / Re: CSMIO IP/A analog spindle RPM
« on: January 10, 2017, 02:17:47 AM »
i have the same parts (csmio-a and keb) with gearing and spindle index sense.

how is the right  setting in the pulley menu?


the  maxium motor rpm is 3000 and my ratio  is 2:1 (spindle speed 1500 rpm)

so i must setting the pulley menu to min speed 0 and max speed 1500 with ratio 2? is this right?

or is the setting min speed 0 and max speed 3000? and is the ratio 2 or 0.5?

9
CS-Lab / Re: how can i use cs labs inputs for brains?
« on: November 27, 2016, 03:18:23 AM »
i need  the inputs/outputs for the gearing
http://www.machsupport.com/forum/index.php/topic,33125.msg233709.html#msg233709
is it possible with a brain?

10
Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT
« on: November 27, 2016, 03:15:05 AM »
this is the gear shifter

is ist a possibility to run it with a brain or works this only with an vba script?

i need/have:
6 inputs for the switches (only for controlling)
6 outputs for the position (to the faller servo box with programmed postions)
1 output for the spindle motor ( to the frequency inverter with an input for a fixed speed , 20 1/min for better gearing)



Pages: 1 2 3 4 5 6 »