6
« on: August 13, 2016, 02:13:59 PM »
If you are referring to ports as in software/firmware, that may be but I know no physical pin have been moved. As it has worked from when I first got the machine new, and does work with some files, I suspect a coding error. Yesterday edited the engraver file while realigning the plate marker. I’ve done that in the past as it’s required when removing/replacing the torch.
I now have a new issue to solve first. I had to plug in a Ethernet cable to down load a print driver so changes the IP address from 9.9.9.1 to auto which requires me to unplug the cable going to the controller. When I reconnected the Ethernet cable to the computer and set the IP back to the proper one is when this started. I’ll upload the file later.
Thanks for the response.
George