1
General Mach Discussion / Re: G code editor
« on: December 31, 2016, 01:51:28 PM »
This is what is in the editor C:\WINN\NOTEPAD.EXE. all caps and it is locked and I cannot edit it. Any suggestions? Thanks
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
If you've slaved it, it should work fine.I have it slaved with the Y axis In Mach but it does not work. Just cant figure out why
Questions...
Have you got the latest plugin, check on the manufacturers website. Cncdrive
Post your profile and someone will have a look at it
You can ask the question on the cncdrive forum website, Balazs is very proactive on there and he knows his product well.
Have you setup the ports and pins and slaved the axis in the configuration screenThank you for the reply