Hello Guest it is March 28, 2024, 06:29:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - crazedflyer

Pages: 1
1
General Mach Discussion / Re: China CNC 6040 Spindle Settings in Mach3
« on: August 01, 2016, 12:03:06 PM »
Use 7Zip to unzip it and you need Adobe software to view it. Hope this helps.

Thanks,
Kelly

2
General Mach Discussion / Re: China CNC 6040 Spindle Settings in Mach3
« on: August 01, 2016, 10:25:21 AM »
I bought a unit that had the limit switches installed, they just had the pins numbered wrong for each axis. But they are not hard to install yourself. I can get you some pics when I get back to the cnc machine, but you can get the manual from http://www.chinacnczone.com/en/desktop-cnc-6040z-cnc-6040-manual-chinacnczone_l62_p10.html and see how to install them yourself. It is only two little metric bolts and the switch with a double stranded wire soldered to them. But look in the manual and see if you already have them first. If you need any other info let me know. I will help if I can.

Thanks,
Kelly

3
Thanks Jim,

I might end up doing the same with manual control. I have the same setup you do with a 2.2kw spindle. I have the manual, but they send one a little out dated. Some of the pins were wrong for the limit switches and there was no mention of the tool zero pin. So I could probably take the cover off and trace wires, but I'm a newbie and learning it too.

I did find the limit switch pins are 11, 12, and 13. Pin 15 is the tool zero and estop is 10.

Thanks for the info,
Kelly

4
General Mach Discussion / China CNC 6040 Spindle Settings in Mach3
« on: July 29, 2016, 06:38:15 PM »
I have just bought a China CNC 6040 and have gotten all of the axis to move, but can't get the spindle to run. Does anyone know what the settings are suppose to be in Mach3 along with the pins on these chinese models. I got the limit switches to work, axis, and auto tool zero, but can't get the spindle to turn via mach3. It does turn on with it set to the controller via the run button and the potentiometer. Would greatly appreciate it if anyone has these settings or knows what to do.

Thanks,
Kelly

Pages: 1