Hello Guest it is March 29, 2024, 08:25:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Theelementofsand

Pages: 1
1
Newfangled Solutions Mach3 Wizards / Re: New mach 3 lathe setup issue
« on: July 19, 2016, 07:25:38 AM »
Sorry that's what I meant

2
Newfangled Solutions Mach3 Wizards / Re: New mach 3 lathe setup issue
« on: July 18, 2016, 10:16:13 PM »
I double checked that and my numbers were right on, then I realized I had homed the tool but had left the part at 0,0 on x and y

3
Newfangled Solutions Mach3 Wizards / Re: New mach 3 lathe setup issue
« on: July 18, 2016, 09:52:17 PM »
Now that you say that, that might be exactly my problem, having swapped the start and stop points when I typed them in.

4
Hello everyone. My name is Danny I'm 30 years old and from Indiana. I have a sherline lathe setup with mach3 and a sherline mill without automation. I look forward to meeting new people here, helping others and getting a little help myself along the way. I'm good with troubleshooting mechanical problems and enjoy small engine repair as well as anything musical.

5
Newfangled Solutions Mach3 Wizards / New mach 3 lathe setup issue
« on: July 18, 2016, 09:20:25 PM »
Hello everyone, I am new here and have a question. Forgive me if this has been asked before but upon searching I didn't not find an answer. So I setup my sherline lathe with mach and am having an issue with the wizards, they want to start at the center of the part and cut outwards rather than outside to the center. I'm sure it's an easy fix but what am I missing? It's basically acting as if I were printing a part rather than cutting it. ???  ???  ???

Thanks ahead of time and let me know if you need any more info.

Pages: 1