Hello Guest it is September 26, 2020, 12:14:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - J-Steel

Pages: 1
General Mach Discussion / Re: Slow jogging
« on: June 20, 2018, 01:38:25 PM »

 I have exactly the same problem SteinarN has.
 I am running Mach3 on Windows 7 64bit in DEMO mode. (Ver. 3.043.066)
 The Motor has 1000 unit/min parameter.
 I got only 168 unit/min (about 1/6 (16.8%) of the maximum) in Jog mode 100% "Jog Rate".
 I have no printer driver installed, I just "playing" with Mach3.
 How is it possible to force Mach 3 to increase this 16.8%?

Thank you in advance!

General Mach Discussion / Re: How to create a plugin for Mach3
« on: July 18, 2016, 03:15:01 PM »
Hello Peta!
I have a question. Which Functions are you using to catch the control signal from Mach?
Thank you for your answer in advance!

Pages: 1