Hello Guest it is December 03, 2020, 11:07:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - kkoninski

Pages: 1
Video P*r*o*b*i*n*g / Re: WebCam Tool measuring
« on: June 18, 2016, 05:23:14 PM »
At the moment I have connected 1 output to probing input. Setting output, SKIP signal is working.
Would be nice if that could be made by programing, not to spend 1Out and 1 In.


Video P*r*o*b*i*n*g / WebCam Tool measuring
« on: June 12, 2016, 06:42:58 AM »
Hello everybody!
I'm new on this forum and Mach3 API but not so new with APIs at all.
I'm trying to make webcam tool measure.

I have already external program which get view of the tool on screen and detect its border.

I can also communicate with Mach3.
What I cannot figure out how to set SKIPSIGNAL trigger by my program using API.

Any help will be welcome.


Pages: 1