Hello Guest it is March 28, 2024, 05:38:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - whensparksfly

Pages: 1
1
Mach3 under Vista / Motor tuning,configuring for mm for plasma tabe
« on: May 26, 2016, 06:23:32 AM »
Hello everyone i have a plasma table i draw on dtaft in mm and then use sheetcam then load to mach three.
Using one motor for each axis.
 My problem is the machine would allway try to go out of the machine boundaries.I plagued a bit with the automatic Moyer tuning in the setting (how far do you want to move how far did it move) it did move 20inchs rather than 20mm I did x u and z do I do a b and c ?
After I done it it have me a knedle speed needs to be incrested wanning. I ran the machine and it seemed very slow and the z seemed to have a kind of its own.

Thanks for any help

Pages: 1