Hello Guest it is January 20, 2021, 08:50:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - pcdoc

Pages: 1
General Mach Discussion / Re: axis won't reverse
« on: June 01, 2017, 04:17:47 PM »
In ports & pins where you setup the motor pins set the X axis only to active low, should go in the correct direction then when you use cursor keys.

General Mach Discussion / Re: How do I get Mach3 to work
« on: June 01, 2017, 04:00:30 PM »
Jim, just a thought, have you configured the hotkeys in mach3 under config? If the cursor (arrow ) keys haven't been set they won't work. I have the 3040T parallel only, once setup it works great.

Pages: 1