Messages

1

Third party software and hardware support forums. / Re: DDCM6V5.0 Breakout Board

« on: May 27, 2016, 06:38:49 PM »

I am having communication issues with the seller. Language barrier and all.  The DDCM6V board I bought has different labels for its terminals.  No surprise there.
 So  What do the following labels stand for?  S 0  : S 1  : S 2  :  S 3  : Z_Se  : Y_Se  : X_Se  : 

2

Third party software and hardware support forums. / Re: DDCM6V5.0 Breakout Board

« on: May 22, 2016, 05:38:25 PM »

OK then,  I should be good to go.  I'll post the results after I try it out.

3

Third party software and hardware support forums. / Re: DDCM6V5.0 Breakout Board

« on: May 22, 2016, 05:10:17 PM »

I know I can run the Mach3 software on Win7 Pro 32-bit.  But as I said in my first post, I upgraded my system to 64-bit.  And the Mach3 page reads like it will not run properly  on a 64-bit system.  Or is that only if I an using a Parallel port, instead of the USB port I plan on using.

4

Third party software and hardware support forums. / Re: DDCM6V5.0 Breakout Board

« on: May 22, 2016, 04:03:12 PM »

It is good to hear that the board will work with Mach3 from you (as well as the seller).   So,  How well will Mach3 run on a Win7 pro  64-Bit system?

5

Third party software and hardware support forums. / DDCM6V5.0 Breakout Board

« on: May 21, 2016, 04:26:53 PM »

I recently purchased a DDCM6V5.0 Breakout Board on EBay.  before it arrived, I updated my system to 64-Bit.  As Mach-3 will not run on a 64-Bit I plan to use Mach-4.  However, the disk that came with the Breakout Board has all I need to run on Mach-3, but Mach-4.  It seems I need a Plugin file that I dont have.   Does anyone have this file?  I am waiting to hear back from the Company I bought the board from, but am impatient.    Thanks