Messages

1

General Mach Discussion / Re: confused and pissed

« on: May 10, 2016, 10:18:10 PM »

Thanks, I'll do that. I was thinking of going with a different system anyhow.

2

General Mach Discussion / Re: confused and pissed

« on: May 10, 2016, 09:25:20 PM »

I've tried that, the other axis becomes the problem

3

General Mach Discussion / confused and pissed

« on: May 10, 2016, 06:05:04 PM »

I built a cnc router using nema 23 270oz. steppers and the tb6560 board. I can jog both x and z axis at slow speed but the y axis just vibrates. I even replaced the tb6560 with a new one and the problem is still there. All the axis will move at high speed including the y axis, but it will not jog at low speed. I've tried about every setting there is with no luck. I'm not using micro steps.