1
VB and the development of wizards / Re: Macro Question...
« on: March 30, 2019, 11:24:51 PM »
I got it figured out, thanks.
Matt
Matt
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
...
N350G00Z0.2000
N360S16000M03
(Step 1 - 8th - Inside Holes)
()
N390G00X4.0365Y4.7133Z0.2000
...
...
N90880G00Z0.2000
N90890S16000M03
(Step 2 - 8th - Slow Profile Cut)
()
N90920G00X0.8160Y92.2155Z0.2000
...
Set objMessage = CreateObject("CDO.Message")
objMessage.Subject = <<LINE IN G-CODE FILE AFTER LINE CONTAINING THE M03 THAT TRIGGERED THE MACRO GOES HERE>>
objMessage.From = """Me"" <me@my.com>"
objMessage.To = "******************xx@*********xx.com" *******************Insert Your Email address
objMessage.TextBody = "This is some sample message text.." & vbCRLF & "It was sent using SMTP authentication."
Depends on the Opto22 relay type. Is it a solid state type or contacts? Is the motor 120 or 220V and what is the HP? The blower motor probably takes 2 or 3 seconds to reach full speed which is fast enough not to cause relay overloading damage. The problem occurs when the motor is turned on and the relay contacts arc for a few millisecond. This causes contact pitting over time and eventual failure.