1
General Mach Discussion / Re: C32 and Clearpath help
« on: May 07, 2016, 06:01:05 AM »
So the fault turned out to be 2 things.
1/ 2 faulty C34CP boards
And
2/ DIP switches. The functional position of the DIPs are as follows. 1off 2on 3on 4off. This is not the positioning instructed in the manual.The servo drivers will only hard enable too.
So servos are running and they are whisper quiet. I'm very pleased with them so far.
1/ 2 faulty C34CP boards
And
2/ DIP switches. The functional position of the DIPs are as follows. 1off 2on 3on 4off. This is not the positioning instructed in the manual.The servo drivers will only hard enable too.
So servos are running and they are whisper quiet. I'm very pleased with them so far.