Hello Guest it is December 04, 2021, 07:51:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - choyle

Pages: 1
1
yes inches

2
Plasma with a light gantry

3
low 20
high 200

4
i have changed the velocity form low and high and back to low and ever where in between.
I believe i'm jogging at 100%

5
Not sure whats going on with my CNC.
when setting up motor tuning i have the motors running grate, when jogging it jogs grate.
when i run a program the G01 is fine i can control the feed rate fine. But G00 no madder
what i do the motors loss steps sound like the motors are over accelerating I've tried changing
setting in motor tuning 100 time. at this point i'm lost

Please help.   

Pages: 1