Hello Guest it is March 29, 2024, 09:45:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dmahaffymetalworks

Pages: 1
1
so i have recently purchased this table and computer that came with it. Mach 3 was already downloaded into the computer along with a program called q-cad. i think that mach 3 is set to recognize a cnc router not a plasma due to the fact that the g-code comes through with a z axis movement of 100, which just makes my stepper motor bottom out and made bad noises. im thinking that there may be something simple to change somewhere that i am just missing but with that said, i am most certainly missing it haha. any help and suggestions would be greatly appreciated as i am totally new to this cnc world. THANKS

Pages: 1