1
VB and the development of wizards / Re: Macro for extension G-code
« on: March 29, 2016, 12:11:16 PM »
I'm using Mach3 to control an old CNC turret puch. There are some Gcode commands for turret puch in .tap file that Mach3 cannot understand (eg: G66I115.J180.P-20.Q-20.D0T256C315) . So I had to write a software to translate these commands to a series of base code (eg: G0 x y, M500) and save to another .tap file. The translated file then can run by mach3