Hello Guest it is March 28, 2024, 10:09:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Tatinc

Pages: 1
1
General Mach Discussion / Re: Safe z question
« on: March 20, 2016, 06:13:33 AM »
It worked.  I had the safe_z setup wrong.  Changed it to -4 machine coordinates and it works great.  Thank you guys for your help.

2
General Mach Discussion / Safe z question
« on: March 15, 2016, 01:22:55 PM »
You guys are great. I will try it tomorrow night.


Sent from my iPhone using Tapatalk

3
General Mach Discussion / Safe z question
« on: March 15, 2016, 08:03:03 AM »
I had my machine set up with a 1.5" safe z. When I hit the stop button on the mach3 screen it would raise the z to 1.5". Now I set up homing switches and when I hit stop it raises the z axis all the way to the top(homed position). Is there a way I can get it to only raise a small amount like it used to?  Also I am using the 2010 screenset.


Sent from my iPhone using Tapatalk

Pages: 1