Messages

1

Mach4 General Discussion / Re: Mach 4 Reference sequence Question

« on: November 11, 2018, 03:37:16 PM »

Thanks so far, but my problem is i don´t know anything about Lua Programming.
How can i get this type of Signal to an output of my controller? That all axes are homed?
 

2

Mach4 General Discussion / Mach 4 Reference sequence Question

« on: November 11, 2018, 04:49:26 AM »

Hi,

is there any possibility to get a output signal from Mach4 who shows the status if the Machine is referenced on all axis?
I have a Signal Pillar which shows me the State of the Machine, if it is Enabled, a ToolChange is needed or if it´s in EStop Condition.
But i don´t know how i can get the Status of a Complete Reference Sequence. Single Axis Referenced signals are easy.


hope someone can help me


Thanks Sven

3

Mach4 Toolbox / Re: Added a Part Runtime to file ops tab

« on: March 13, 2016, 09:43:51 AM »

Hi,
Sorry that i have to reopen this topic, but i don´t get the Runtime Counter to work i have added the scripts to the PLC and the Reset button as above mentioned.
But how do i get the Readings to the Textbox? I don´t have any knowledge in Programming.