1
General Mach Discussion / Re: Mach config
« on: March 13, 2016, 02:54:38 PM »
Thanks for your reply
yesterday i work on the machine an the pc.
first time i change the spindle wire , i put a isolated cable and put it on the ground .
the machine works better but i 'll have some jerky yet ...
i put the computer chassis to the ground also and at this time the machine works fine .
only one question stay without answer, why the same parameters works diffrently with 2 diffrents computers ...
Eric
yesterday i work on the machine an the pc.
first time i change the spindle wire , i put a isolated cable and put it on the ground .
the machine works better but i 'll have some jerky yet ...
i put the computer chassis to the ground also and at this time the machine works fine .
only one question stay without answer, why the same parameters works diffrently with 2 diffrents computers ...
Eric