Hello Guest it is May 18, 2021, 05:08:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - raymondbyrd

Pages: 1
1
General Mach Discussion / Re: Master Axis and Slave Axis out of sync
« on: February 26, 2016, 04:03:04 PM »
It does this in both directions, however at higher speeds the Y axis will jump back and forth before actually starting.

2
General Mach Discussion / Re: Master Axis and Slave Axis out of sync
« on: February 26, 2016, 04:02:01 PM »
Yes one side begins to move about a second before the other. I have checked the tracks, all motor connections and even switched motors, thinking a motor may have been bad. None of these have fixed it. I have also gone through motor tuning and made sure everything is equal and got nothing as well. I am about to try the other thing you suggested

3
General Mach Discussion / Master Axis and Slave Axis out of sync
« on: February 26, 2016, 03:15:06 PM »
Let me preface by saying I am an extreme novice with CNC software. I purchased a routing table with mach3 yesterday off of craigslist and was able to get it to run ok, but have been plagued by a slave axis that is about a second behind the master axis. I have been through different pages on this forum already in an attempt to solve the problem but so far have been unable to do so. Any help I could get would be immensely appreciated.

Pages: 1