Messages

1

Mach4 General Discussion / Re: Mach 4 and Galil

« on: March 08, 2016, 08:31:49 PM »

Steve,

Any update available for the Galil plug-in?

Regards,
Jeff

2

Galil / Galil ICM20105

« on: March 05, 2016, 10:51:09 PM »

I have 1 Galil DMC 2183 with 2 ICM20105 cards. 
I've been able to configure my limit switched to work correctly in Mach3.
I have a speed encoder for my spindle RPMs which is wired into the Jaux port on the ICM20105.
I need help configuring the inputs for this in Mach3.

Thanks,
Jeff

3

Modbus / Automation Direct DL205 Modbus setup with Mach3

« on: March 01, 2016, 01:59:27 PM »

Recently, I  purchased a Wells-Index 833 CNC mill which the previous owner started the conversion to  a new controller and DL2056 PLC.
The controller is a Galil DMC 2183 which I have working with Mach3.  
My issue is setting up the PLC over Ethernet Modbus for spindle control (FWD & REV).
While I can control the spindle thru the DirectLogic software, I'm have an issue tying it all together and working thru Mach3.
One of the reasons for the PLC is the previous owner created to analog panels. One of the panels has a MPG.

All help is appreciated.

Thanks,
Jeff