1
General Mach Discussion / Re: Stepper motor acting funny
« on: February 28, 2016, 09:55:28 AM »
Hi everybody !
I tryed to install LinuxCNC, and now my stepper motors are moving as supposed.
I want to thank you all for your great support, and best of luck for all of you.
This thread can be closed now.
Regards, Beni.
I tryed to install LinuxCNC, and now my stepper motors are moving as supposed.
I want to thank you all for your great support, and best of luck for all of you.
This thread can be closed now.
Regards, Beni.