Hello Guest it is October 14, 2019, 02:54:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jasongib

Pages: 1
1
Share Your GCode / Re: 90 degree sharp turns
« on: February 23, 2016, 09:45:33 AM »
Yes! Pretty good corners. Thank you for your kind comments.

Jason

2
Share Your GCode / Re: 90 degree sharp turns
« on: February 22, 2016, 02:31:39 PM »
Hello, thank you for that. Will give it a try:)
Many thanks

3
Share Your GCode / 90 degree sharp turns
« on: February 22, 2016, 12:55:15 PM »
Hello,

Hope someone can advice me please.

I'm new to this, got my machine setup and calibrated.

I'm trying to do a square but my corners are being cut slightly rounded. I would like them to be 90degree turns.

If there anyway to do this properly?

I'm using DevFoam pro and Mach 3.
Thank you

Pages: 1