Hello Guest it is December 04, 2020, 06:25:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - zne89

Pages: 1
1
General Mach Discussion / Re: HOW configure on Mach3
« on: February 15, 2016, 06:41:15 PM »
Rather than repeat everything here, the Mach3 manual contains full details of how to go about its' configuration in relation to your particular stepper motor and your chosen micro-stepping. http://www.machsupport.com/help-learning/product-manuals/

Your maximum stepper motor current is shown as 5A and your stepper motor driver dip switches should be set to this figure (or just slightly less [4.45A]) - refer to your equipment manufacturer's data sheets for more details.

Tweakie.
Need a help

2
General Mach Discussion / Re: HOW configure on Mach3
« on: February 15, 2016, 04:53:16 PM »
I try it gives its not normal



3
General Mach Discussion / Re: HOW configure on Mach3
« on: February 15, 2016, 05:28:58 AM »
haw to config SW4.SW5.SW6.SW7.SW8
THE ORIGINAL CONFIG

4
General Mach Discussion / HOW configure on Mach3
« on: February 14, 2016, 08:23:53 PM »
HOW configure on Mach3this stepper motor

and stepper motor driver


Pages: 1