Hello Guest it is March 28, 2024, 06:14:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MariusNita

Pages: 1
1
Mach4 General Discussion / Re: Auto Touch Module
« on: October 20, 2016, 03:04:02 PM »
I'll let you know about these

2
Mach4 General Discussion / Re: Auto Touch Module
« on: October 19, 2016, 12:22:55 AM »
It is blue when my probe is not touching.
Ok, so what shall I do in this case?


3
Mach4 General Discussion / Re: Auto Touch Module
« on: October 18, 2016, 05:14:08 PM »
Please have a look over the printscreen.

As you can see the Selected probe is currently active is blue.

An error appears: Unexpected probe touch. So I know I am missing something but I cannot figure it out.


4
Mach4 General Discussion / Re: Auto Touch Module
« on: October 18, 2016, 12:44:41 AM »
It is active, the problem is it doesn't stop and does not retract.
Am I doing something wrong?

Can you send a link with a short movie?

5
Mach4 General Discussion / Auto Touch Module
« on: October 17, 2016, 03:07:20 PM »
Hello, I have installed the latest version Version Mach4_Hobby 2.0.3206 and I used the Touch button.

After pressing the button, the motor starts running, the tool touches the touch plate but does not stop and the potential risk is to damage the tool.

I am using paralel port (Darwin plugin).

Can someone help me?


6
Mach4 General Discussion / Re: Can someone better explain probing setup?
« on: February 08, 2016, 12:58:13 PM »
Hello,
I just bought license for Mach 4 and for Darwin plugin.
I want to mention that I am new on this, so please do not get me wrong if I will say something stupid.
The the machine is working, I forgot to mention, I am using Mach4 version 2.2872 and Darwin plugin version 2.2763.
What I would need is two things:
First, I need to know if there is an “Auto Tool Zero” script that allows me to check the height of each mill I am changing the mills manually. So if there is, I home someone can provide it.
Second, I need to turn the piece and to mill it also on one side. To do this this, I would need to setup again the X, Y and Z but taking in consideration the new position of the piece. So, I need to do a probe and to find out the new X, the new Y and the new Z coordinates. More than this, I need to use the tool itself as a touch probe. So does know somebody how to do it?
If there is someone that can help me, I need explanation step by step, as I mentioned I am new with Mach4.

Pages: 1