Messages

1

General Mach Discussion / Re: Y axis not moving or power up

« on: February 01, 2016, 10:05:08 PM »

Hi I am Kobus Minnaar and new to CNC. I building a CNC but got a problem and don't know if this is hardware or software. I send my Board a TB6560 3 axis to a electronic store and pay more to repair than i paid for it and still not working. My X axis and Z axis work correct and the led light come on when you power it up but the Y axis is dead, When you power it up there is nothing. They fitted a new Driver but it dont seem to be it. Is there any way to test the incoming signal to see if it power the drivers up

Sorry forgot, the DRO work and if I swap the motors over they work so it is the Y axis

2

General Mach Discussion / Y axis not moving or power up

« on: February 01, 2016, 09:14:19 PM »

Hi I am Kobus Minnaar and new to CNC. I building a CNC but got a problem and don't know if this is hardware or software. I send my Board a TB6560 3 axis to a electronic store and pay more to repair than i paid for it and still not working. My X axis and Z axis work correct and the led light come on when you power it up but the Y axis is dead, When you power it up there is nothing. They fitted a new Driver but it dont seem to be it. Is there any way to test the incoming signal to see if it power the drivers up