Hello Guest it is April 10, 2021, 08:44:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - enterpryse

Pages: 1
1
General Mach Discussion / Re: Simple question but I guess lots of opinions
« on: February 02, 2016, 03:36:43 AM »
Bearing in mind that I am a noob at this and only really wanting to do 2d (or 2.5d if I knew what it was) to start do you think M4 is the better long term solution for me?

I loaded it last night and prefer the graphics as they are a lot clearer to me but didn't get chance to fire it up and configure it.

One more thing DeseignCad seems to do the CAD and CAM (two products) why don't I read much about it on the forum? It's priced about right for me and seems to offer everything I might need?

Great website BTW Tweakie....

Once again, thanks.....

2
General Mach Discussion / Re: Simple question but I guess lots of opinions
« on: February 01, 2016, 12:21:55 PM »
Why not test drive Mach4 and see for yourself which you'd prefer?

Fair point, well made!

3
General Mach Discussion / Re: Simple question but I guess lots of opinions
« on: February 01, 2016, 12:20:56 PM »
In that case is there anything that M3 can do that M4 can't? and....
will I understand the answer ;-)   

Tweakie, are you still on M3 because of the hassle and downtime upgrading.

Thanks guys...


4
General Mach Discussion / Simple question but I guess lots of opinions
« on: February 01, 2016, 11:26:34 AM »
I've just built my system which is quite simple and am test driving Mach3 and about to press the purchase button but before I do (and with future upgrades in my mind) would it be better to go for Mach4 with a parallel port plugin?

Thanks

Pages: 1