Messages

1

Newfangled Solutions Mach3 Wizards / Re: Newfangled shapes

« on: November 28, 2005, 09:23:43 AM »

Without seeing the wizard, I can't be sure if these are appropriate but:
Engraved dial markings, text etc..
XLR conntecters and their mounting holes.
IEC power connections.
Those pain in the ass, press fit cable clamps with thier flat sided holes.

At what point does your add in become a low end cad package?

PK

2

Newfangled Solutions Mach3 Wizards / Re: Newfangled shapes

« on: November 28, 2005, 08:01:22 AM »

Potentiometer holes with the second, little hole for the locating pin.
Panel meters..... or am I missing something

3

General Mach Discussion / Re: Jogging vs G1

« on: October 26, 2005, 02:52:56 AM »

Great, enhanced pulsing got it sorted. Many thanks.
To change the topic. What's the current deal with licensing for Mach3? So far I've downloaded what seems to be a commercial quality app and am running it for nothing? How/When do I pay for this?

PK

4

General Mach Discussion / Jogging vs G1

« on: October 25, 2005, 10:37:14 PM »

OK I'll start by saying that I know I've done something wrong. I just cant figure out what it is..

I have an axis, configured and tuned such that I can jog at 6m/min.
If I try to move it using g1 in a program, it stalls at 3m/min.

I've checked that the jog speed is at 100%
I've tried inverting the logic of the step pin.
I'm running Mach3 Mill, Engine R1.83.003
Accelleration is low.

Any thoughts