Hello Guest it is August 19, 2022, 04:32:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mcdaniel01

Pages: 1
I am very new to building cnc plasma table , although i have ran Messers titan version productively . My real question here has anyone seen any videos of setting up a oxy fuel setup with mach.

Thanks ! i need to try and get some information . Anyone had any luck controlling a oxy fuel torch with mach firing the torch , preheat delay pierce delay , i think i know how i can do it manually like fabricating a second control station for lighting the torch preheating and creating a power button for opening a solenoid for cutting oxygen . But is there a way to do it withinn the parameters of mach. Just got interested in building my own cnc plasma table in the 3 months or so , is it best to buy the bladerunner kit from candcnc or build your own power supply with the geko G540 . Thanks Jason Mcdaniel

Pages: 1