Messages

1

FAQs / Re: set delay for spindle spin up

« on: January 16, 2016, 01:43:57 PM »

Got it I had tried it before but it didn't seem to work.

2

FAQs / set delay for spindle spin up

« on: January 16, 2016, 12:42:42 PM »

Where in mach3 can you set a delay that delays the g-code from running until the spindle is up to speed. 6 sec or 7 sec , or do you have to do it in the g-code.

Thanks

3

FAQs / Re: How do you install the PWM drive

« on: January 10, 2016, 07:23:32 PM »

Windows XP

4

FAQs / Re: How do you install the PWM drive

« on: January 10, 2016, 06:30:51 PM »

Window 95 and a parallel port.
The spindle will not start. All the axes are working.

Carol

5

FAQs / Re: How do you install the PWM drive

« on: January 10, 2016, 01:16:45 PM »

The pulse engine mite be installed but the windows driver is not. It should be in the device manager and it is not in there. If you go to the Device Manager and add a new device go to manual install others you see the device mach pulsing engine and it asks for an INF file in the mach3 directory there is a mach3.inf, if you tell it to open this file it returns a screen that say's no information for the driver found. The mach3 install manual on page 2-10 tells you how to install the driver that is what I followed. If that doesn't work where can I go to get an answer???

Sorry just been working on this for 2 or 3 days and am feed-up.

Carol

6

FAQs / Re: How do you install the PWM drive

« on: January 09, 2016, 05:56:51 PM »

I did that and the test seems to say the system is OK. I can't get the driver to show up in the device manager. It should show up as Mach X Pulsing Engines with a sub driver of mach3 Driver. In the install manual there is a reference to the installation of this driver Page 2-10 when I do this it comes back with there is no reference to this driver.

Carol
 

7

FAQs / Re: How do you install the PWM drive

« on: January 09, 2016, 04:13:37 PM »

I used the wrong name it is the pulsing engine. sorry
Carol

8

FAQs / Re: How do you install the PWM drive

« on: January 09, 2016, 04:01:14 PM »

I am trying to install a variable speed spindle on my CNC and the mach3 PWM drivers will not install. Followed the directions in the manual and the system said that their is no information in the mach3.inf file. I am installing this on an XP machine. Any clue to what I am doing wrong.

Carol 

9

FAQs / How do you install the PWM drive

« on: January 09, 2016, 01:47:50 PM »

I have a Mach3  setup and running but the PWM driver didn't get installed. How do I get it in the system.

Thanks

Carol