Hello Guest it is February 27, 2020, 06:20:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - leversole

Pages: 1 2 3 4 5 6 7 8 9 10 11 »
1
Okay thanks!

Does anyone else have a source for something similar? May try to build one out of a snap switch just to see how repeatable it might be,,,


Thanks

2
Hey Tweakie....I know this is an old post..but I am tired of alligator cliipping the ground to my router bits!!!! Looking to get a switch type to set my Z height...I know you sold your design, where can I get one?

Thanks
Leslie

3
Mach Screens / Re: Key simulators
« on: January 22, 2017, 11:28:21 AM »
Tweakie if you like I can post/send the VCarve file or the GCode...

4
Mach Screens / Re: Key simulators
« on: January 21, 2017, 05:59:45 PM »
Pretty simple once I got into it...may get clever and put a backspace key in at some point...this is my manual screen and my main screen


5
Mach Screens / Re: Key simulators
« on: January 20, 2017, 03:07:58 PM »
If I get this to work, at the end I have to make the MDI equal to the test string...I am at work and not able to look in any of the Mach manuals, but how would I go about actually "executing" this? As I am typing this, maybe it does not have to acutally go to the MDI, I could writer code to simply run the string....hmmmmmmm...so I could use a "fake" mdi (the userlabel that represents the string I built) and have a go button to build the code to run...

will give it a try...

Leslie

6
Mach Screens / Re: Key simulators
« on: January 20, 2017, 03:04:25 PM »
Thanks!  ;D ;D ;D

7
Mach Screens / Re: Key simulators
« on: January 20, 2017, 02:50:52 PM »
I'll bet that is it..."msgtext" is not a global variable! I assumed it was...so if it was local, it would behave as it is...good suggestion! I will try to write it to a dro. I can make a DRO a string correct?

Thanks
Leslie

8
Machscreen Screen Designer / Re: Main Screen Disapearance!
« on: January 15, 2017, 06:24:52 PM »
Thanks...will try it out tomorrow...watching football and eating wings right now!   ;D

9
Machscreen Screen Designer / Main Screen Disapearance!
« on: January 15, 2017, 02:57:18 PM »
Suddenly, the main window in Mach Screen disappeared?!? Only the properties window shows…I rebooted, uninstalled, reinstalled ver 64 (was using ver 66)…still whenever I start Mach Screen the main window loads for a split second, then disappears, leaving behind the properties window…
Even looked for a registry setting, cannot figure this one out...
Any ideas?

Thank You
Leslie

10
VB and the development of wizards / Re: Visibility or color property
« on: January 11, 2017, 06:23:56 PM »
May be getting closer!

Pages: 1 2 3 4 5 6 7 8 9 10 11 »