1
General Mach Discussion / Re: Slave axis is not moving on G-code
« on: December 20, 2015, 04:01:04 PM »
Hi!
Find software my new project, but i have in Mach3 same issue.
Loading sample G-code and it runs only the Y axis moves, slave A not moving at all?In jogging mode Y and A moves together nicely.
Using breakout board (STB4100) and ST-40-45-A1 controllers.
All best,
Priit
Find software my new project, but i have in Mach3 same issue.
Loading sample G-code and it runs only the Y axis moves, slave A not moving at all?In jogging mode Y and A moves together nicely.
Using breakout board (STB4100) and ST-40-45-A1 controllers.
All best,
Priit