1
General Mach Discussion / Re: Mach3, Leadshine MX4660, UC100 CNC motion controller and problems with Auto Zero
« on: August 29, 2016, 08:26:14 PM »
OK I found the solution.
Looking closer to input4 and the manual again I figured that there is no power...I found another thread on the XZero forum where somebody showed his way to wire proximity switches. Long story short, you have to bridge power from +V12 VDCout to the optocoupler, then it works.
Easy ... HaHaHa...
Anyhow problem solved, thanks for your input and help!
Looking closer to input4 and the manual again I figured that there is no power...I found another thread on the XZero forum where somebody showed his way to wire proximity switches. Long story short, you have to bridge power from +V12 VDCout to the optocoupler, then it works.
Easy ... HaHaHa...
Anyhow problem solved, thanks for your input and help!