3
« on: May 09, 2016, 11:29:35 PM »
Hey everyone I am having trouble w program. It was running fine until I started to add another clean up pass. It shows a solid line on the tool paths but when I try to generate the program it doesn't show it as the actual tool path but when I run it it it does take the solid line path.. It acts like it doesn't like when I call for a g01. When I enter a g00 it seems run okay but I can't use a g00 because it's too fast of a feed into the part. Is there anyway to change the federate on a g00? And is there a difference between a g00 and a g01 besides the rapid feedrate? Any help or ideas would be much appreciated thanx all.