Hello Guest it is March 29, 2024, 01:52:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hdglider50

Pages: 1
1
General Mach Discussion / Re: Steps per unit help
« on: November 26, 2018, 05:30:50 PM »
seem to have corrected my problems by making the adjustsments on my laptop, windows 8 and transfering the files to my desktop windows 10. still not able to open a motor tuning window on my desktop windows 10, no screen :(

2
General Mach Discussion / Re: Steps per unit help
« on: November 26, 2018, 10:54:54 AM »
hope I did this correct.

I have been making changes in my laptop and moving the files to my desk top and have corrected the steps, I believe. My Z runs about 1/8 above my project. I still do not have a motor tuning screen. It seems to be OK on my laptop, windows 8. it I my desktop windows 10 that is giving me problems.

3
General Mach Discussion / Re: missing motor tuning screen mach3
« on: November 25, 2018, 06:57:13 PM »
 I down loaded the UC100 down load and enabled it. It works fine on my laptop with Windows 8. Im trying to use it on my new computer with Windows 10. It had been working but i needed to reset my steps per units, thats when I had problems with the X axis. So i figured i needed to retune the motors and thats when i noticed the window wont open. all other windows open OK.

4
General Mach Discussion / Steps per unit help
« on: November 24, 2018, 09:31:08 AM »
I have had mach 3 for about three years now and just realized, i never setup the steps per unit.  So i tried and now I need help. My X axis worked OK, the Y axis just vibrates and wont move now. I figured I would try to reset the motor tuning but no window pops up. All other windows popup OK. Any idea what I did?

5
General Mach Discussion / Re: missing motor tuning screen mach3
« on: November 23, 2018, 05:26:39 PM »
I'm having the same problem, no motor tuning screen. i'm using the UC100 USB adapter. Will the drivers reset work for me also. It has been running OK, just wanted to set the steps per unit and my Y axis wont work. Thought I would reset motor tuning but no screen. any help would be greatly appreciated.

Pages: 1