Messages

1

Feature Requests / Re: POLL: Mach3 Lathe and G70/G71/G72 roughing, facing, finishing

« on: December 04, 2015, 10:35:12 AM »

YES I TOTALLY AGREE, EVEN WITH CAM SOFTWARE, THESE CANNED CYCLES ARE HERY HELPFUL AND SHOULD BE INCLUDED AS DEFAULT G-CODE.
The G77 code seems to be linear moves only, but we need the profile control of G71,G72, G70.

Thanks for the efforts to get it done.

  Later. ~ John

2

General Mach Discussion / Re: Problem with new machine.

« on: November 09, 2015, 07:45:46 PM »

I think I have the same machine, shopmaster 2015 mill turn, So far the only problem I have is the Z axis becoming intermittent after a few moves.
 Not familiar with MACH 3 yet. and this machine only has virtual limit switches. I have checked the cables and still having problem.
 any thoughts for help ?