1
General Mach Discussion / Re: best intro software for very basic lettering to be cut on a 20x14cm machine.
« on: November 26, 2015, 04:15:21 AM »
hey,, very impressed with vectric, plus i bought v carve photo, which is great to use, and on a whole, a lot easier to navigate and design.than some other softwares, but as i learned , i would benefit from a number of different software packages. so , i bought the artcam express, its, ok and obviously gives different features etc, but when i went to save g code, because i didn't on the trial, or couldn't, i noticed that the post processor setting mach 2/3(mm)*(txt), was not listed .!
so ive trawled the forums, and still cant get a definitive way forward for my circumstances..
i work in MM not inches, and dont really want to reconfigure my machine?? if thats even possible. So please if any one has any advise on this, many thanks
so ive trawled the forums, and still cant get a definitive way forward for my circumstances..
i work in MM not inches, and dont really want to reconfigure my machine?? if thats even possible. So please if any one has any advise on this, many thanks