Hello Guest it is March 28, 2024, 08:08:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Johnhol

Pages: 1
1
General Mach Discussion / Re: Denford Orac tool changer problem.
« on: October 24, 2015, 02:12:03 PM »
Hi Rich,

The code I input is T0101M6.

John.


2
General Mach Discussion / Denford Orac tool changer problem.
« on: October 23, 2015, 03:45:26 PM »
Hi all,

I recently acquired a friends Denford Orac lathe which he had converted to run on mach3. Everything seems to work ok apart from the tool changer which once given a command rotates continuously and doesn't stop. I'm not sure if its a soft wear issue ( macro) or a sensor problem. Has anyone had such a problem or at least have an Idea what it could be?

Cheers John.

Pages: 1